Redline Communications Inc. RDL3100RMA Manuale Utente
RDL-3100 M2M Solutions
70-00184-05-00
Proprietary Redline Communications © 2017
Page
30
of 33
July 14, 2017
5
Regulatory Notices
5.1.1 FCC Notices
Deployment in USA
The following notices about deployment in the USA are included in training and
documentation provided to professional installers and operators of the final product:
documentation provided to professional installers and operators of the final product:
1.
The final product must be professionally installed.
2.
WARNING -- FCC RF Exposure Warnings
To satisfy FCC RF exposure requirements for RF transmitting devices, the following
distances should be maintained between the antenna of this device and persons
during device operation:
distances should be maintained between the antenna of this device and persons
during device operation:
Table 84: FCC: RDL-3100-RMA Recommended Safe Distances
Frequency (MHz)
Deployment
Separation Distance
4900
PMP/PTP
220 cm (86.6") or more
5200
PMP
20 cm (7.8") or more
5300
PMP/PTP
20 cm (7.8") or more
5400
PMP/PTP
20 cm (7.8") or more
5800
PMP
20 cm (7.8") or more
5800
PTP
220 cm (86.6") or more
To ensure compliance, operation at closer than these distances is not
recommended. The antenna used for this transmitter must not be collocated in
conjunction with any other antenna or transmitter.
recommended. The antenna used for this transmitter must not be collocated in
conjunction with any other antenna or transmitter.
3.
FCC Information to Users @ FCC 15.105:
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Where DFS is required by regional regulations, this function is permanently enabled
at the factory and can not be disabled by the installer or end-user.
at the factory and can not be disabled by the installer or end-user.
4.
FCC Information to Users @ FCC 15.19:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
two conditions: