PointRed Telecom Ltd. MCRD-2458 Manuale Utente

M i c r o R e d   &   M i c r o V i e w   N M S   U s e r   M a n u a l   v 1 . 0

Page 56

WDS Node – 1 configuration should include the following: 

x

WDS Node – 2’s MAC address should be set in Node – 1’s WDS list. 

x

Both nodes should transmit on the same frequency. 

x

Additionally, you can enable an ACL with Policy set up to Deny and no 
node’s MAC address in the list to prevent stations from connecting to the 
node.

The same configuration should be set in WDS Node – 2, with corresponding 
values.

AP to AP-Client Scenario 
You can set up a Point-to-Point link using AP and AP Client Modes. 

Figure 54. Point-to-Point Topology

The access point should be configured as follows: 

x

Set up the ESSID of the AP. 

x

Enable ACL with Policy set up to ALLOW and put the AP-Client’s MAC 
address in the MAC list. 

The AP-Client should be configured as follows: 

x

Type the AP’s MAC address into the SSID field. 

x

Type the MAC address of the AP into the Preferred BSSID field. 

x

Perform a Site Survey. 

x

Select the AP from list and perform an Align. 

x

Make all the adjustments to achieve optimal alignment results. 

Repeater is a custom mode of MicroRed. Repeater functionality is described in 
the Operational Modes section of this document.