Captivate Network 6F127021 Manuale Utente
Captivate Network
Elevator Company Scope of Work
5 Elevators
1. All work to be completed during normal business hours. Written quotes are
required and should be sent to the attention of the Project Supervisor performing
the site survey. Quotes should be submitted in a timely fashion, 3-5 business
days is requested. Once Captivate Network accepts the quote, a written purchase
order will be created and sent to the appropriate person and address noted on the
quote. All billing and invoices must reference the purchase order number and sent
to Captivate at the following location. The invoice must be an original. Copies
and faxed documents Will Not be accepted and will delay payment. All work
should be performed during normal working hours.
the site survey. Quotes should be submitted in a timely fashion, 3-5 business
days is requested. Once Captivate Network accepts the quote, a written purchase
order will be created and sent to the appropriate person and address noted on the
quote. All billing and invoices must reference the purchase order number and sent
to Captivate at the following location. The invoice must be an original. Copies
and faxed documents Will Not be accepted and will delay payment. All work
should be performed during normal working hours.
Attn: Accounts Payable
Captivate Network
2 Executive Drive, Suite 301
Chelmsford, MA 01824
2. Apply for permits. A copy of the permit must be sent to Captivate. All work
should be done in compliance with the ASME 17 Code for Elevators and
Escalators and the National Electrical Code (NEC) where applicable. Also
observe any local codes that may differentiate from the above codes. This is the
responsibility of the elevator contractor.
Escalators and the National Electrical Code (NEC) where applicable. Also
observe any local codes that may differentiate from the above codes. This is the
responsibility of the elevator contractor.
3. Install the display system in the elevator cabs. The estimated time is 2 hours to
mount the display and antenna assembly.
Elevator Power Electrical Specifications
Input voltage 100 – 120 volts AC
Frequency 60
Input voltage 100 – 120 volts AC
Frequency 60
Hz
Input current (maximum)
1 amp
Typical input current 0.30 amps @ 110 volts AC
Maximum Power
Maximum Power
50 watts
Maximum Heat Load 170.645 BTU/Hr.
4. Locate cab-top-power for the display system. The power cord from the display is
14 AWG and typical load is 0.36 amps @ 110 VAC or 40 watts. Use conduit
wherever required by code.
wherever required by code.