Advanced Control Technologies Inc. 0792-01 Manuale Utente

Z-Wave ZDW120 Instructions, Series 300, Release 3.10 

P/D 060210

0795-01

1

The ZDW120 Wall Mounted Dimmer is a component of the HomePro lighting control system.   Wire the Wall 

Mounted Dimmer in place of the standard wall switch according to the diagram above and program from the 

Wireless Controller to operate loads.   Inclusion of the ZDW120 Wall Mounted Dimmer on the ZTH100 Wireless 

Controller menu allows remote ON/OFF control and dimming of lights connected.  
This Wall Mounted Dimmer is designed to work with other Z-Wave enabled devices.  Z-Wave nodes of other 

types can be added to the system and will also act as repeaters if they support this function of repeating the 

signal received to other modules in the system.   
This product supports 40Kbps data transmission.  This product can also be used for networking support in 

systems that stream metadata. An example might include transmission of information from audio devices such 

as song title, artist, and album information to various displays around the home.
As part of a Z-Wave network, the ZDW120 will also act as a wireless repeater to insure that commands intended 

for another device in the network are received.  This is useful when the device would otherwise be out of the 

radio range of the wireless controller. 
There are no field repairable assemblies on this unit. If service is needed, the unit must be returned where 

purchased. 
Read and understand these instructions before installing.  This device is intended for installation in accordance 

with the National Electric code and local regulations in the United States, or the Canadian Electrical Code and 

local regulations in Canada.  It is recommended that a qualified electrician perform this installation.
CAUTION!  To reduce the risk of overheating and possible damage to other equipment, do not install to 

control a receptacle, a motor operated appliance, a fluorescent lighting fixture, or a transformer-supplied ap-

pliance, but only permanently installed incandescent lamp fixtures.  Make sure the lamp(s) to be controlled 

directly from this dimmer total no more than 500 watts.  Retain instructions for future use.

DANGER!  -  SHOCK HAZARD.  Make all connections with the POWER OFF to avoid injury to the installer or 

damage  

 

 

 to the device.    

1.  Strip 3/4” of insulation from the ends of the conductors (if not already done) and make connec-

tions as shown in the Wiring Diagram.  Note that the line side of the load must be switched. 

Supplied with matching deco-

rative switch plate

Note:  This module must be “Included in the 

Network” 

installed.  The proper operation of  this node in 

the mesh network is dependent on it knowing its 

location with respect to other nodes.  You cannot 

“test bench” configure this module.

•  This product supports Zensor Net Beam technology