Vivato Inc. VLJ24WFSW Manuale Utente

Timeout: Enter the maximum number of seconds to wait for a reply from the RADIUS server 
after an authentication request is sent.

MaxRetry: Enter the maximum number of times a packet is re-transmitted to the RADIUS 
server without a reply from the server before ending the authentication attempt. The default 
is 1.

Add: Click to add this server to the list of available servers.

After an authentication server has been configured, you can change its settings and click on Make 
Changes to put those changes into effect. You can also click on Delete to remove that 
authentication server’s configuration.

These settings are used to specify EAP operating conditions and devices:

EAP Status: Select Enabled or Disabled to turn EAP on or off when you select Make Changes.

Max-Auth-Error: Enter the maximum amount of authentication errors that occur within the 
time specified by the auth-threshold that are allowed during the authentication attempt 
before an authentication failure is reported and the client is blocked from further 
authentication attempts. A typical value is 3.

Max-Encrypt-Error: Enter the maximum number of encryption errors from the client that are 
allowed during the time specified in Auth Threshold before an authentication failure is 
reported. A typical value is 3.

Auth Threshold: The amount of time, in minutes, used to measure client authentication errors 
for the Max-Encrypt-Error command. The value must be in the range of 1 to 60; a typical value 
is 20.

Encrypt Threshold: Enter the length of time, in minutes, that the Max-Encrypt-Error command 
uses to measure encryption errors in packets before disassociating the client from the Wi-Fi 
Switch. The value must be in the range of 1 to 10; a typical value is 5.

Delete this authentication 
server profile.

Enter configuration 
changes.