Tranzeo Wireless Technologies Inc GNVPZ1NT3 Manuale Utente
Chapter 15: Controlling Access to the EnRoute500
TR0153 Rev. E1
120
The ACL for a VAP must be enabled after it has been created. Choose “blacklist” from the
drop-down menu and click on “Change ACL Mode” to enable the list. Choose “none” from the
drop-down menu and click on “Change ACL Mode” to disable the ACL.
Figure 51. AP ACL configuration
15.6.2
Mesh ACL
The access control list (ACL) for the mesh interface blocks access to the EnRoute500 via the
mesh interface for any mesh device whose mesh MAC address is not listed in the ACL.
mesh interface for any mesh device whose mesh MAC address is not listed in the ACL.
It is possible to isolate a mesh device from other devices in the mesh if the
mesh ACL is incorrectly configured. If the mesh ACL is enabled and no MAC
addresses are present on the list, or the wrong addresses are present, it will
not be possible for other mesh devices to communicate with the device.
mesh ACL is incorrectly configured. If the mesh ACL is enabled and no MAC
addresses are present on the list, or the wrong addresses are present, it will
not be possible for other mesh devices to communicate with the device.
Web GUI
The mesh ACL can be defined via the web interface on the “Mesh” sub-tab under the “ACL”
tab on the “Security” page as shown in Figure 52. Enter a MAC address and click on the “Add
MAC” button to add the address to the ACL for that VAP. Once an address has been added, it
tab on the “Security” page as shown in Figure 52. Enter a MAC address and click on the “Add
MAC” button to add the address to the ACL for that VAP. Once an address has been added, it