Tranzeo Wireless Technologies Inc GNVPZ1NT3 Manuale Utente

Chapter 18: Integration with Enterprise Equipment

TR0153 Rev. E1

130

17 Enabling VLAN Tagging

The EnRoute500 supports VLAN tagging, with each client access interface capable of
supporting a different VLAN tag.

17.1 Client Access Interface Configuration

VLAN tagging can be independently controlled on each client access interface (eth0, wlan1-4).
The Enable VLAN parameters for the ‘eth0’, ‘wlan1’, ‘wlan2’, ‘wlan3’, and ‘wlan4’ interfaces
controls the state of VLAN tagging.

VLAN tagging must be enabled on the backhaul Ethernet interface on a mesh
neighborhood’s gateway for VLAN tags to be included in data frames sent to
the WAN. See section 17.2 for more details.

The VLAN ID value for each client access interface is set with the VLAN ID parameter for each
interface. The VLAN ID must be in the range from 0 to 4095. Note that 0 and 4095 are
reserved values and 1 is the default VLAN ID. There are no restrictions on VLAN IDs for
different interfaces or mesh devices having to match or be different.

CLI

The example below shows how to enable VLAN tagging on the ‘wlan1’ interface and set the
VLAN ID to 12 using the parameters ‘vlan.enable’ and ‘vlan.id’ in the ‘wlan1’ interface.

> use wlan1
wlan1> set vlan.enable=yes
> use wlan1
wlan1> set vlan.id=12

Web GUI

The VLAN Enable and VLAN ID parameters can be set via the web interface under the
“wlanN” tabs on the “Wireless Interfaces” page and on the “Wired/Backhaul Interface” page
(see Figure 57).