Tranzeo Wireless Technologies Inc GNVPZ1NT3 Manuale Utente
Chapter 7: Configuration Profile Management
TR0153 Rev. E1
47
7.2
Load a Configuration Profile
A configuration stored on the EnRoute500 can be applied using the “Load” tab on the “Profile
Management” page. This profile must either have been saved earlier or uploaded to the
EnRoute500. Choose a profile name from the “Existing Profiles” box and then click on “Load
Profile”. It is necessary to reboot the EnRoute500 for the loaded profile settings to take effect.
Management” page. This profile must either have been saved earlier or uploaded to the
EnRoute500. Choose a profile name from the “Existing Profiles” box and then click on “Load
Profile”. It is necessary to reboot the EnRoute500 for the loaded profile settings to take effect.
A number of default configuration profiles are available on the EnRoute1000. There
is a “FACTORY” profile, which contains the default settings for the firmware version
that is installed. By applying this profile, an EnRoute500 will revert to the default
settings for that particular firmware version. If the EnRoute500 firmware has been
upgraded, there will also be a profile with the same name as the firmware version,
e.g. ENROUTE500_20060419_00_00_0133. This profile contains the settings that
were set when the new firmware was installed. If you wish to roll back to the settings
that were originally set when a particular firmware version was installed, apply the
profile with the name that matches the firmware version name.
is a “FACTORY” profile, which contains the default settings for the firmware version
that is installed. By applying this profile, an EnRoute500 will revert to the default
settings for that particular firmware version. If the EnRoute500 firmware has been
upgraded, there will also be a profile with the same name as the firmware version,
e.g. ENROUTE500_20060419_00_00_0133. This profile contains the settings that
were set when the new firmware was installed. If you wish to roll back to the settings
that were originally set when a particular firmware version was installed, apply the
profile with the name that matches the firmware version name.
Figure 20. Load a configuration profile