Tranzeo Wireless Technologies Inc GNVPZ1NT3 Manuale Utente
Chapter 8: System Settings
TR0153 Rev. E1
54
It is recommended that the mesh prefix default value of 172.29 is used.
CLI
The mesh prefix is set with the ‘id.meshprefix’ parameter in the ‘sys’ interface as shown in the
example below.
example below.
> use sys
sys> set id.meshprefix=172.29
sys> set id.meshprefix=172.29
Web GUI
The mesh prefix can be set via the web interface using the “Mesh” tab on the “Wireless
Interfaces” page.
Interfaces” page.
Figure 27. Setting the mesh prefix
8.6
Internal and External Subnets
The EnRoute500s in a mesh neighborhood must be aware of which addresses are located
within the mesh and which are external to the mesh. The addresses that fall within the mesh
are considered internal, and those that are located on the WAN-side of the mesh
neighborhood’s gateway(s) are considered external.
within the mesh and which are external to the mesh. The addresses that fall within the mesh
are considered internal, and those that are located on the WAN-side of the mesh
neighborhood’s gateway(s) are considered external.