Tranzeo Wireless Technologies Inc GNVPZ1NT3 Manuale Utente
Chapter 9: Client Addressing Schemes
TR0153 Rev. E1
68
The default division of the class C address space is shown in Table 7. It is possible to change
this configuration, assigning larger address spaces to certain interfaces if not all interfaces are
enabled.
this configuration, assigning larger address spaces to certain interfaces if not all interfaces are
enabled.
Interface
Interface address
Broadcast address
Client device address range
wlan1
subnet.1
subnet.127
subnet.2-126
wlan2
subnet.129
subnet.159
subnet.130-158
wlan3
subnet.161
subnet.191
subnet.162-190
wlan4
subnet.193
subnet.223
subnet.194-222
eth0
subnet.225
subnet.255
subnet.226-254
subnet = <id.lanprefix>.<id.mesh>.<id.node>
Table 7. Default subnet segmentation between interfaces
9.1.1
LAN Prefix
The LAN prefix parameter sets the first octet of the client access interface IP address. The
suggested values for the LAN prefix are 10 and 192. The LAN prefix must be the same for all
devices in a mesh neighborhood.
The LAN prefix parameter has no effect when an EnRoute500 is using the explicit addressing
scheme.
suggested values for the LAN prefix are 10 and 192. The LAN prefix must be the same for all
devices in a mesh neighborhood.
The LAN prefix parameter has no effect when an EnRoute500 is using the explicit addressing
scheme.
CLI
The LAN prefix is set with the ‘id.lanprefix’ parameter in the ‘sys’ interface as shown in the
example below.
example below.
> use sys
sys> id.lanprefix=10
sys> id.lanprefix=10
Web GUI
The LAN prefix can be set via the web interface using the “System” tab on the “System
Parameters” page (see Figure 36).
Parameters” page (see Figure 36).
9.1.2
Client Address Space Segmentation in Implicit Addressing Mode
As mentioned above, the client access interfaces must share a class C address space when
the EnRoute500 is using the implicit addressing scheme. The start address of each address
segment and its size can be set. The following restrictions are placed on the address segment
configuration:
• Each active client access interface must be assigned an address segment.
the EnRoute500 is using the implicit addressing scheme. The start address of each address
segment and its size can be set. The following restrictions are placed on the address segment
configuration:
• Each active client access interface must be assigned an address segment.