Tranzeo Wireless Technologies Inc GNVPZ1NT3 Manuale Utente
Chapter 9: Client Addressing Schemes
TR0153 Rev. E1
71
9.2
Explicit Addressing Scheme
When using explicit addressing scheme, the IP parameters for each interface must be
specified manually on the “Wireless Interface” and “Wired/Backhaul Interface” pages.
When specifying the IP addresses and subnet sizes for the client access interfaces, the
following rules should be followed:
specified manually on the “Wireless Interface” and “Wired/Backhaul Interface” pages.
When specifying the IP addresses and subnet sizes for the client access interfaces, the
following rules should be followed:
• Specify IP address and subnet combinations that do not lead to misalignment, e.g.
10.0.0.4/24 is not a properly aligned address/subnet size combination.
• Do not specify subnets that are in the following ranges:
o
169.254.0.0/16
o
127.0.0.0/8
o
The class B network used by the mesh (typically 172.29.0.0/16)
• Each subnet specified for a client access interface must not overlap with that of any
other client access interface in the mesh neighborhood.
• Do not specify any subnets for client access interfaces that overlap with subnets outside
the mesh neighborhood that you want mesh clients to be able to connect to.
Do not specify a gateway IP address for any of the client access interfaces
when operating using the explicit addressing scheme. This field should be left
blank for each interface.
when operating using the explicit addressing scheme. This field should be left
blank for each interface.
CLI
Set the ‘implicit.enable’ parameter in the ‘mesh0’ interface to ‘no’ to select the explicit
addressing scheme. The example below demonstrates this.
addressing scheme. The example below demonstrates this.
> use mesh0
sys>
sys>
set implicit.enable=no
See sections 11.1.2 and 12.4 for instructions on how to set the IP addresses for the wired and
wireless client access interfaces when using the explicit addressing scheme.
Web GUI
The addressing scheme is set with the “Implicit Addressing” drop-down menu on the “System”
tab of the “System” page (see Figure 36). Set this to “disabled” to use the explicit addressing
scheme.
See sections 11.1.2 and 12.4 for instructions on how to set the IP addresses for the wired and
wireless client access interfaces when using the explicit addressing scheme.
tab of the “System” page (see Figure 36). Set this to “disabled” to use the explicit addressing
scheme.
See sections 11.1.2 and 12.4 for instructions on how to set the IP addresses for the wired and
wireless client access interfaces when using the explicit addressing scheme.