Tranzeo Wireless Technologies Inc GNVPZ1NT3 Manuale Utente
Chapter 12: Virtual Access Point (VAP)
Configuration
TR0153 Rev. E1
92
Figure 45. Access point authentication and encryption settings
12.9.1
WEP Encryption
The VAPs can be protected with a WEP-based encryption key to prevent unauthorized users
from intercepting or spoofing traffic.
from intercepting or spoofing traffic.
CLI
To enable WEP-based encryption, set the ‘key’ parameter in the ‘wlanN’ interface. The length
of the encryption key is determined by the format used to specify the ‘key’ value. Valid key
formats and the corresponding encryption type and key length are listed in Table 12.
of the encryption key is determined by the format used to specify the ‘key’ value. Valid key
formats and the corresponding encryption type and key length are listed in Table 12.
If WPA is enabled for an interface (‘wpa.enable’ CLI parameter in the ‘wlanN’
interfaces), the WPA settings will be used for encryption and authentication
and the ‘key’ value used to enable WEP will be ignored.
interfaces), the WPA settings will be used for encryption and authentication
and the ‘key’ value used to enable WEP will be ignored.