FreeWave Technologies Inc. 6231812519 Manuale Utente
Table 6. Troubleshooting Guidelines
CONDITION
POSSIBLE CAUSE
POSSIBLE CORRECTIVE ACTION
Power LED on
Low SAFECONNECT
Replace Belt Bridge batteries
SAFECONNECT Belt batteries
Bridge is RED
Bridge is RED
POWER LED on
Sirius Wireless Link
Replace Wireless Link battery
SAFECONNECT Belt
battery is low
Bridge is ORANGE
POWER LED on
Failure to press the
Press the ON/OFF button until all
SAFECONNECT
ON/OFF button for
three LEDs turn green
Belt Bridge is OFF
a full second
Low batteries
Replace batteries
Unit inoperative
Return unit to factory for repair
COMM LED on
Absence of Bluetooth
Momentarily press the LINK button
SAFECONNECT Belt
link between Wireless
while both devices are within range
Bridge is ORANGE
Link and Belt Bridge
Reset Wireless Link by pressing
LINK button for five seconds;
then, attempt to establish link
LINK button for five seconds;
then, attempt to establish link
Replace Wireless Link battery and
attempt to establish LINK
attempt to establish LINK
Absence of link between
Wireless Link should be seated or
Wireless LINK and
mated properly with Sirius
Sirius instrument
instrument in boot
At cold temperatures
Cycle power on Sirius instrument to
(<0°C) loss of communi-
reinitialize communication.
cation can occur
Wear Sirius instrument close to body
to keep it warm.
to keep it warm.
Sirius instrument is OFF
Turn instrument ON, wait until
start-up routine is complete, and
attempt to establish LINK
start-up routine is complete, and
attempt to establish LINK
Direct, bright sunlight on
Ensure that provided MSA label is
IRDA communication
installed at top of Sirius unit and
from Sirius to Sirius
providing sunlight shield
Wireless Link can cause
loss of communication
loss of communication
COMM LED on
SAFECOM unit is OFF
Turn SAFECOM unit ON
SAFECONNECT
Belt Bridge is RED
(Belt Bridge is not
connected to
SAFESITE network)
Belt Bridge is RED
(Belt Bridge is not
connected to
SAFESITE network)
Incorrect network ID
Return unit to factory for proper
and/or frequency key on
configuration
Belt Bridge
Belt Bridge out of
Belt Bridge will automatically
network range
reconnect when it is in network
range
range
Radio inoperative
Return unit to factory for repair
10