Alvarion Technologies Ltd. BMAX-BA36 Manuale Utente

Installing the Base Station Equipment

BreezeMAX Modular Base Station System Manual

55

Firmly push in the module into its intended slot.

Press the handle down until you hear the locking click and the red button is 
released.

Secure the module in place by closing the screw at the top of the front panel.

Release the screws at the top and the bottom of the front panel.

Press the handles' red button until the handles are unlocked.

Wait until the blue HOT SWAP LED turns on, indicationg that the module has 
been disconnected and can be removed. 

Press the handles down (the upper handle)/up (the lower handle) until the 
module is unlocked, firmly hold the handles and take the module out of the 
chassis. 

If a module is fully inserted without properly locking the handles, it will become operational. 
However, in this state the hot-swap mechanism is not supported. A warning message (trap) will be 
sent.

In a PIU without HOT SWAP LED, disconnect power from the PIU module before inserting it to the 
chassis. 

In a PIU with HOT SWAP LED, disconnect power from the PIU module only after it is taken out from 
the chassis (or after the HOT SWAP LED is turned on).