Alvarion Technologies Ltd. BMAX-BA36 Manuale Utente
68
Installation
Chapter 2 - Installation Guidelines
2.4.3
Installing the GPS Adapter
1
The GPS Adapter is installed on the 1U high panel that can be used also for
installation of ODU Power Feeder modules. The panel is supplied with blank
installation of ODU Power Feeder modules. The panel is supplied with blank
ODU GPS
RJ-45 jack
1PPS (RS-442 interface) from Outdoor GPS Receiver
Serial control signals (RS-422 interface) to Outdoor GPS Receiver
Power (12 VDC) to Outdoor GPS Receiver
(GND)
Grounding Screw
Connection to ground (earth)
Table 2-16: GPS Adapter LEDs
Name
Description
Functionality
PWR
Input power indication
Off - Power input failure
Green - 12 VDC power supply from NPU is OK
1PPS
1PPS signal indication
Blinking Green - 1PPS signal from GPS Receiver
is detected
is detected
Red - 1PPS signal is not detected
Active GPS - ODU
ODU GPS selection indication
Green - indicates that the selected GPS Receiver:
is ODU (Outdoor)
is ODU (Outdoor)
Off - ODU GPS Receiver is not selected
Active GPS - IDU
IDU GPS selection indication
Green - indicates that the selected GPS Receiver:
is IDU (Indoor)
is IDU (Indoor)
Off - IDU GPS Receiver is not selected
Active GPS - INT
INT GPS selection indication
Green - indicates that the selected GPS Receiver:
is INT (Internal). Internal is not supported in current
release.
is INT (Internal). Internal is not supported in current
release.
Off - INT GPS Receiver is not selected
INT CLOCK
Internal clock source indication
Green - Internal 16MHz clock is ok (not supported
in current release)
in current release)
Red - Internal clock is not available or clock failure
To install the GPS Adapter:
Table 2-15: GPS Adapter Connectors
Name
Connector
Functionality