Autostart AS6601 Manuale Utente

P. 8 User 

Guide 

Setting Your Vehicle Into Ready Mode 

If your vehicle has a manual transmission you must read the following instructions. In order to start 
the vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to Ready 
Mode, it cannot remote-start the vehicle. 
Once the system is set to Ready Mode, the vehicle can be remote-started and stopped at wish.  

To set the system to Ready Mode: 
1.  Ensure that all the doors are closed and that the shifter is in the 

position. 

2.  With the engine already running, apply the parking brake and release the brake pedal. 

3.  Within 20 sec. press 

, 

 or 

 on the transmitter. 

4.  Remove the key: the engine will go on running. 
5.  Exit the vehicle and close the door. 
6.  Press and hold either: 

a. 

 to lock the doors and shut down the engine;

 

b. 

 to unlock the doors and shut down the engine; 

c. 

 to shut down the engine without affecting the doors. 

7.  The        icon will appear on your screen. 

Remaining In Ready Mode 

Once the vehicle is in Ready Mode you can start and stop the vehicle at wish. However, should 
any of the following occur, the vehicle will exit Ready Mode – thus eliminating the remote start 
option until Ready Mode is restored: 

•  Door opened; 

•  Hood opened; 

•  Brake pedal pressed; 

•  Parking brake disengaged; 

•  Ignition key turned to the 

 position. 

Note:  The unit will notify the user that it has exited Ready Mode by giving 3 slow flashes 
(parking lights).

 

Remote starting 

Press the   button for approximately 1 second. The LCD will display “START” with the backlight 
ON for 1 second. The parking lights will come 

 to inform you that the remote starter has received 

your signal. Approximately 5 seconds later, the engine will start. The parking lights will remain 

 

during the pre-programmed run time of the engine.  
If the vehicle does not start at the first attempt, the system will shut down.

 

If your vehicle is 

equipped with an automatic transmission, there will be 3 start attempts before the system gives up. 

Driving Off 

With the vehicle running under remote control, press the        button to disarm and unlock the 
doors. Enter the vehicle and do the following: 

Turn the ignition key to the 

 position. (Do not turn the key to the 

 position 

while the engine is running. This would cause the starter motor to re-engage.) 

Press the brake pedal to disengage the remote starter unit. 

You are now ready to drive off. 

Arming the Starter Kill 

 

The starter kill (if installed) can be configured by the installer so as to arm automatically (passive 

mode) or not to arm automatically (active mode).