Novatel Wireless NRM-EU870D Manuale Utente

Pagina di 85
 
 
75
 
Novatel Wireless  
 
 
 
 
 
 
Revision 1  
 
 
 
The EU860D and EU870D products will comply with the applicable GSM/GPRS European 
Regional Regulatory Requirements as per the following table. 
GSM/GPRS European Regulations 
GSM 11.10 / 
TS 51.010 
Requirement 
Description 
EU / 
R&TTE 
Directive 
12.1.1 
Conducted spurious emissions - MS allocated a channel 
Yes 
12.1.2 
Conducted spurious emissions - MS in idle mode 
Yes 
12.2.1 
Radiated spurious emissions - MS allocated a channel 
Yes 
12.2.2 
Radiated spurious emissions - MS in idle mode 
Yes 
13.1 
Transmitter – Frequency error and phase error 
Yes 
13.2 
Transmitter – Frequency error under multipath and interference conditions 
Yes 
13.3-1 
Transmitter output power and burst timing - MS with permanent antenna 
connector 
Yes 
13.4 
Transmitter - Output RF spectrum 
Yes 
13.6 
Transmitter – Frequency error and phase error in HSCSD multislot 
configuration 
Yes 
13.7 
Transmitter output power and burst timing in HSCSD configurations 
Yes 
13.8 
Transmitter, Output RF spectrum in HSCSD multislot configuration 
Yes 
13.16.1 
Frequency error and phase error in GPRS multislot configuration 
Yes 
13.16.2 
Transmitter output power in GPRS multislot configuration 
Yes 
13.16.3 
Output RF spectrum in GPRS multislot configuration 
Yes 
13.17.1 
Frequency error and Modulation accuracy in EGPRS Configuration 
Yes 
13.17.2 
Frequency error under multipath and interference conditions in EGPRS 
Configuration 
Yes 
13.17.3-1 
EGPRS Transmitter output power- MS with permanent antenna connector 
Yes 
13.17.4 
Output RF spectrum in EGPRS Configuration 
Yes 
14.7.1 
Blocking and spurious response - speech channels 
Yes 
14.18.5 
Blocking and spurious response in EGPRS Configuration 
Yes 
 
                                                                                                                                                              
CDMA Direct Spread (UTRA FDD) (UE) covering essential requirements of article 3.2 of the 
R&TTE Directive