Tad Radio of Canada Inc M10B Manuale Utente
FRONT PANEL CONTROLS
Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Warning Statement
Changes or modifications not expressly approved by the manufacturer void the user’s authority to
operate the equipment.
Power SW and Volume [1]
The radio is turned on and off pushing this control.(Push on, off) The audio level from the speaker
increases as this control is rotated clock-wise.
Squelch Control [2]
Squelch Control [2]
This controls the receiver silencing circuitry. To correctly utilize this control, first select an unused
channel, then rotate it counter-clockwise until noise is heard in the speaker and the ”BUSY” indicator
shows in the display. Now rotate the control clockwise until the noise is squelched and the “BUSY”
indicator goes out on the display. This is the most sensitive setting for this control. Rotating this
control further clockwise decreases the sensitivity of the receiver. This is sometimes handy in noisy
conditions.
Channel selector knob [3]
shows in the display. Now rotate the control clockwise until the noise is squelched and the “BUSY”
indicator goes out on the display. This is the most sensitive setting for this control. Rotating this
control further clockwise decreases the sensitivity of the receiver. This is sometimes handy in noisy
conditions.
Channel selector knob [3]
Use this control to select a channel.
Panel Buttons [4]
The four front panel buttons perform two functions each. The first one is performed when the button
is pressed and then released after the first “beep”. The second function is performed when the
buttons pressed and held in for 2-3 seconds and a second beep is heard.
buttons pressed and held in for 2-3 seconds and a second beep is heard.
When the panel button is pressed and released after the first “beep”:
The “SCAN” button toggles the radio in and out of the scan mode. The “SCAN” indicator, on the
display, will be “on” when in the scan mode.
The “DISP” button changes the display from channel number only, to channel number and an
alphanumeric name (up to 7 characters), to channel number and frequency, to channel
number and tone frequency, then back to channel number only.
number and tone frequency, then back to channel number only.
The “PRI” button toggles the radio in and out of the priority mode. The “PRI” indicator, on the
display, will be on when in the priority mode.
The “PRG” button puts the radio into the “User Programming Mode.” The “U PROG” indicator,
on the display, will be “on” when in the user programming mode.
When the panel button is pressed and held until the second “beep”:
The “SCAN”(A/D) button adds or deletes the channel from the scan sequence. The "D”
indicator is turned on when the channel is deleted from the scan sequence. (The channel will
not be scanned if it is deleted from the scan sequence.)
not be scanned if it is deleted from the scan sequence.)
The “DISP” (DIM) button toggles the display back-lighting between dim and normal.
The “PRI” (L/N) button toggles the receiver between “normal” and “low” sensitivity. (The “LOW”
The “PRI” (L/N) button toggles the receiver between “normal” and “low” sensitivity. (The “LOW”
indicator is on when the receiver is least sensitive.)
The “PRG” button causes the radio to enter the “PASS NUMBER” mode for dealer
programming. (Works only if the internal “OPTION SWITCH” is set for this mode.)
SCAN MODE
When the “SCAN” indicator is “on” the radio will scan all the channels that have been entered into
the scan sequence whenever the microphone is hung up. When the radio comes to a channel for