A Four Tech Co Ltd RFKB25A Manuale Utente

 

4 

1. 

Make sure that your computer is turned off. 

2. 

Connecting the Receiver’s Keyboard Cable: 

(a)  When connecting to an IBM AT keyboard port, use the 5-pin DIN connector already attached to the 

keyboard cable. 

(b)  When connecting to a PS/2 -style, 6-pin DIN keyboard port, remove the AT adapter.  

(c)  Connect the receiver’s purple keyboard cable to the computer’s keyboard port. 

3. 

Connecting the Receiver’s Mouse Cable (Wireless Desktop): Connect the receiver’s green mouse cable to the computer’s PS/2 mouse port  

4. 

Place the receiver eight inches (20 centimeters) from any 

electromechanical device. 

Before you can take advantage of the many features your mouse and keyboard 

offers, you must install the driver. The driver is in the installation diskette that 

came packaged with your mouse and keyboard 

Windows 95/98/Me/2000/NT4.0 installation 

Insert the installation diskette into your floppy disk drive. 

Click the Start button and then click Run. 

In the Run dialog window, type A:\setup, where “A” is the letter of your floppy disk drive. 

Click O K and follow the instructions on your screen to complete the installation. 

The Wireless keyboard and Mouse operates on two frequency channels. To prevent interference when using two 

RF Mice in close proximity a different frequency channel should be used for each mouse. Refer to the 

following to change the frequency channel for your keyboard and mouse: Set the frequency channel on the receiver to 1 or 2. Set the frequency channel on the keyboard and mouse to 1 or 2.   

Each keyboard and mouse is assigned a unique ID code at manufacture, 

so the receiver only picks up the signal from your mouse and prevents other Wireless keyboard or mouse radio signals from 

operating on your computer. This feature can also be disabled, allowing other Wireless pointing devices to operate your computer.