A Four Tech Co Ltd RMOP57P Manuale Utente
— 3 —
Windows 95/98/2000/NT4.0/ME/XP installation
1.
Connect the mouse to your computer.
2.
Insert the installation diskette into your floppy disk drive.
3.
Click the Start button and then click Run.
4.
In the Run dialog window, type A:\setup, where “A” is the letter of your floppy disk drive.
5.
Click O K and follow the instructions on your screen to complete the installation.
The RF-Mouse ID code
Each RF-Mouse is assigned a unique ID code at manufacture, so the receiver only picks up the signal from your mouse and prevents other RF-Mouse radio signals
from operating on your computer. This feature can also be disabled, allowing other RF -pointing devices to operate your computer.
from operating on your computer. This feature can also be disabled, allowing other RF -pointing devices to operate your computer.
Connecting the RF-Mouse ID Code
When the driver installation is finished your computer reboots and the
RF-Mouse window (shown on the right) appears.
CONNECT ID: Move the RF-Mouse for a few seconds to establish a
connection, then click Connect ID . The unique ID code of your
mouse is recognized and another RF pointing device will not function
on your computer.
mouse is recognized and another RF pointing device will not function
on your computer.
Exit: Click Exit if no other RF pointing devices are within 3 meters
range or if you want other RF pointing devices to be able to access
your computer.
range or if you want other RF pointing devices to be able to access
your computer.
Changing the RF-Mouse ID Code
You can use a new RF -Mouse on your computer without changing the Ra dio receiver; you just need to change the ID code. Refer to the following:
1. Press [Shift + Alt + F11] or [Shift + Alt + F12] to call up the RF-Mouse ID Code window.
2. Move the RF-Mouse for a few seconds to establish a connection, then click Connect ID.
3. The ne w ID code is Connected and the RF -Mouse window closes.
4. Click Exit to close the RF-Mouse ID code window.
Identifying Components
The mouse is designed to fit snugly into your hand. The scroll wheel is positioned on the top allowing
for easy operation with th e index finger. Standard mouse buttons are positioned to either side of the
scroll wheels and can be reached comfortably with the index and ring fingers. A third button is placed
under the vertical wheel and can be easily clicked by pushing down on the whe el.
for easy operation with th e index finger. Standard mouse buttons are positioned to either side of the
scroll wheels and can be reached comfortably with the index and ring fingers. A third button is placed
under the vertical wheel and can be easily clicked by pushing down on the whe el.
The following pages will tell you how to configure the scroll wheels and buttons to suit your specific
needs.
needs.
Cleaning the Mouse
Clean the mouse regularly to ensure efficient operation. Refer to the following:
1.
Rotate the housing cover counterclockwise until it unlocks and remove it.
2.
Remove the tracking ball.
3.
Wash the tracking ball with warm water and soap then allow it to dry.
4.
Use a cotton swab and alcohol to clean the tracking rollers in the housing.
5.
Replace the tracking ball and the housing cove r.
6.
Rotate the housing cover clockwise until it locks in place.