Honeywell International Inc. 7400-352 Manuale Utente

•

)

To maintain top performance from batteries, follow the guidelines below when
storing them:

Avoid storing batteries outside of the specified range of -4 to 104° F ( -20 to 40°C)
or in extremely high humidity.

For prolonged storage, do not keep batteries stored in a charger that is connected
to a power source.

During long-term storage, battery deactivation may tend to occur which may
cause charging to stop early during recharging after storage. This issue can be
handled by charging and discharging the battery several times. Also, the first
charging after prolonged storage may yield a lower than normal capacity. While
this will vary depending on the storage conditions, charging and discharging the
battery several times will almost completely restore capacity.

)

If you encounter problems with the Dolphin 7400 QuadCharger, refer to chart
below for possible solutions. If problems persist, please contact Hand Held
Products Technical Support.

Problem

Issue

The ‘CHARGING” LED does not
come on when I insert a battery pack
into the Dolphin 7400 QuadCharger

Check the power connections on the
Dolphin 7400 QuadCharger. Also
check to ensure the POWER switch
is ON and the battery pack is
properly seated.

The red status LED comes on during
charging.

Try to charge the battery in one of the
other charging pockets. If the red
Status LED comes on again, then the
problem is associated with the
battery pack. If the red status stays
with the charging pocket, the problem
is associated with the charging
circuity.

The red status LED remains on
without a battery in the charging
pocket.

An error occurred during the self-
diagnostic test for that particular
charging pocket. Call Hand Held
Products Technical Support.