Honeywell International Inc. 7400-476 Manuale Utente
2 - 5
4 Align the Screen and Set the Time Zone
Aligning the Screen
You will be prompted to align the screen after a cold boot. Alignment can also be performed by going to Start>Settings and
then choosing ‘Screen’ on the "Systems" tab. Follow the directions on the screen to align the screen and keep the following
points in mind:
then choosing ‘Screen’ on the "Systems" tab. Follow the directions on the screen to align the screen and keep the following
points in mind:
•
After the Welcome splash screen appears, you will be prompted to calibrate the screen. The Dolphin 7400/7450 terminal
displays a cross-hair target and a message to "Tap the target firmly……".
displays a cross-hair target and a message to "Tap the target firmly……".
•
Use the stylus shipped with your Dolphin mobile computer. Alignment should always be performed with a stylus designed
for touchscreen applications. The small point is required for accurate calibration.
for touchscreen applications. The small point is required for accurate calibration.
•
The stylus should be oriented at a 90 degree angle to the screen surface. Press the stylus firmly into the center of the cross-
hair target and release. Do not "double-tap" the target. You will be prompted to repeat this process for a total of five targets.
hair target and release. Do not "double-tap" the target. You will be prompted to repeat this process for a total of five targets.
•
After aligning the screen, follow the directions on the screen which take you through a simple exercise showing how to use
the stylus and pop-up menus.
the stylus and pop-up menus.
Tapping the Target
Using Pop-Up Menus