Honeywell International Inc. CS19A Manuale Utente

5 - 2

symbology to which you want to apply the prefix or suffix.  For 
example, for Code 128, Code ID is “j” and Hex ID is “6A”.

Scan the 2 hex digits from the 

cover of this manual or scan 9, 9 for all symbologies.

Determine the hex value from the 

on page A-4, for the prefix or suffix you wish to enter. 

 inside the 

back cover of this manual.

Repeat Steps 4 and 5 for every prefix or suffix character.

To add the Code I.D., scan 5, C, 8, 0.

 To add AIM I.D., scan 5, C, 8, 1.
 To add a backslash (\), scan 5, C, 5, C.

Note: To add a backslash (\) as in Step 7, you must scan 5C twice – once 

to create the leading backslash and then to create the backslash 

itself.

Scan Save to exit and save, or scan Discard to exit without saving.

Repeat Steps 1-6 to add a prefix or suffix for another symbology.

To send a CR (carriage return)Suffix for U.P.C. only:

Scan Add Suffix.

Determine the 2 digit hex value from the Symbology Chart 

(included in the 

U.P.C..

Scan 6, 3 from the 

manual.

Determine the hex value from the 

Scan 0, D from the 

 inside the back cover of this 

manual.

Scan Save, or scan Discard to exit without saving.

You can clear a single prefix or suffix, or clear all prefixes/suffixes for a 
symbology.  If you have been entering prefixes and suffixes for single sym-
bologies, you can use Clear One Prefix (Suffix) to delete a specific char-
acter from a symbology.  When you Clear All Prefixes (Suffixes), all the 
prefixes or suffixes for a symbology are deleted.

Preliminary Draft