Honeywell International Inc. CS19A Manuale Utente

8 - 2

An image is taken whenever the hardware button is pressed, or when the Image 
Snap (IMGSNP) command is processed.    

The image snap command has many different modifiers that can be used to 
change the look of the image in memory.  Modifiers always begin with numbers 
and end with a letter (case insensitive).  Any number of modifiers may be 
appended to the IMGSNP command.  For example, you can use the following 
command to snap an image, increase the gain, and have the beeper sound 
once the snap is complete:  IMGSNP2G1B

  

This sets the Image Snap style.  

0P Decoding Style.  This processing allows a few frames to be taken 

until the exposure parameters are met.  The last frame is then 
available for further use.

1P Photo Style  (default)

.  This mimics a simple digital camera, and 

results in a visually optimized image.

2P Manual Style.  This is an advanced style that should only be used 

by an experienced user.  It allows you the most freedom to set up 
the scanner, and has no auto-exposure.

Causes a beep to sound after an image is snapped.

0B No beep 

(default)

1B Sounds a beep when the image is captured. 

Waits for a hardware button push before taking the image.  This is only 
available when using Photo Style (1P).

0T Takes image immediately 

(default)

1T Waits for a button push, then takes the image

Determines if the LEDs should be on or off, and when.  Ambient illumina-
tion (0L) is preferred for taking pictures of color documents, such as ID 
cards, especially when the scanner is in a stand.  LED illumination (1L) is 
preferred when the scanner is handheld.  LED State is not available when 
using Decoding Style  (0P).  

0L LEDs off 

(default)

1L LEDs on 

Preliminary Draft