Honeywell International Inc. CX85WCR Manuale Utente
Troubleshooting
8-2
DIAD 6 Charge Rack Manual
Symptoms
Cause
Suggested Action
Terminal LED not illumi-
nated on all 30 bays (all
five banks).
nated on all 30 bays (all
five banks).
Charge rack is not receiving
power
power
Verify that the power cord is not dam-
aged and is properly plugged into the
rack and outlet.
aged and is properly plugged into the
rack and outlet.
Verify the outlet has power. Check the
fuse or circuit breaker.
fuse or circuit breaker.
If a power strip or surge protector is
used, verify that it is turned on and
functioning properly.
used, verify that it is turned on and
functioning properly.
Big harness failure/connec-
tion issue
tion issue
Verify that the big harness is properly
connected to the power supply. If nec-
essary, replace the big harness with kit
part #200004056CNRKIT (see page
connected to the power supply. If nec-
essary, replace the big harness with kit
part #200004056CNRKIT (see page
Power supply failure
Replace the power supply with kit part
#100008187CNRKIT (see page
#100008187CNRKIT (see page
Terminal fits loosely in a
single bay.
single bay.
Terminal not seated properly
Verify that the terminal is pressed firmly
into the bay.
into the bay.
Terminal LED begin flash-
ing in the middle of
charging.
ing in the middle of
charging.
Terminal’s battery has
stopped charging due to
excessive heat or cold
stopped charging due to
excessive heat or cold
Allow the terminal to return to normal
temperature, then retest. It may be nec-
essary to operate the rack in a tempera-
ture-controlled environment.
temperature, then retest. It may be nec-
essary to operate the rack in a tempera-
ture-controlled environment.
Terminal battery failure
If charging does not resume after the
terminal has returned to normal tem-
perature, send the terminal in for repair.
terminal has returned to normal tem-
perature, send the terminal in for repair.
Defective terminal
Send the terminal in for repair.
Poor contact between connec-
tor on distribution board to
power supply cable
tor on distribution board to
power supply cable