Honeywell International Inc. 7850LPE Manuale Utente

There are two ways to reset the Dolphin terminal: a soft reset and a hard reset. 

A soft reset re-boots the device without losing RAM data. You would perform a soft reset 1) when the terminal fails to respond, 
2) after installing software applications that require a reboot, or 3) after making changes to certain system settings.

1. Press and hold the Red 

 + ESC 

 keys for approximately five seconds. The screen turns white and the decode and 

scan LEDs flash for approximately three seconds. 

2. When the reset is complete, the Today screen displays.

1. Press and hold the Red 

 + Tab 

 keys for approximately five seconds. The screen turns white and the decode and 

scan LEDs light for approximately three seconds. 

2. The terminal re-initializes; see 

Set the time and date after each hard reset to ensure that the system clock is real-time. Tap the date on the Today screen to 
open the Clock setting and set the time and date. 

Suspend mode suspends terminal operation. The terminal appears to be “off” when in suspend mode.

The terminal is programmed to go into suspend mode automatically when inactive for a specified period of time. You can set this 
time period in the Power setting. For details, see the Advanced Tab section of the 

 (see page 6-11) setting.

Press the Blue 

 + Backlight 

 keys.  You should put the terminal in suspend mode when you change the battery pack; 

To resume terminal operation (or “wake” the terminal), 

•

Press the Backlight key 

.

•

Press the 

If the terminal does not wake when you press the scan trigger,

•

The battery door may not be fully closed. The mechanical switch in the battery door prevents the terminal from resuming 
operations unless the door is closed.

•

The main battery might be too low to resume operations. Remove the battery and install a fully charged battery or connect the 
terminal to a Dolphin charging peripheral.

!