Honeywell International Inc. 950003 Manuale Utente
13 - 2
Dolphin® 9500/9550 Mobile Computer User’s Guide
Rear Panel
Power Supply Connector
Use this connector to attach the power supply to the QuadCharger. The universal power supply accepts input voltages between
90-265 volts.
90-265 volts.
Charging Batteries In The QuadCharger
Follow these steps to charge batteries in the QuadCharger:
1. Set up the charger for use
2. Supply power
3. Insert batteries
CAUTION: Do not attempt to recharge any battery pack in the Dolphin 9500/9550 QuadCharger that is not manufactured
by HHP especially for this device. To do so will void your warranty and could damage the Dolphin 9500/9550
QuadCharger.
by HHP especially for this device. To do so will void your warranty and could damage the Dolphin 9500/9550
QuadCharger.
Setting Up The QuadCharger
The Dolphin QuadCharger should be set up on any dry, stable surface. DIN rail slots on the bottom panel allow the charger to
be wall or desktop-mounted for easily adapting the unit to your environment.
be wall or desktop-mounted for easily adapting the unit to your environment.
The charger must be connected to a power source for any type of operation.
Supplying Power To The QuadCharger
CAUTION: Using a non-HHP power cord voids your warranty and could result in serious damage to the Dolphin
QuadCharger’s circuitry.
QuadCharger’s circuitry.
Locate the AC power cord that came with the Dolphin QuadCharger. Plug the cord into the power supply connector on the back
of the unit and then plug the power cord into a wall socket.
of the unit and then plug the power cord into a wall socket.
Press the toggle switch to turn on the Dolphin 9500/9550 QuadCharger. The GREEN power LED will illuminate and the charger
will undergo a self-diagnostic test.
will undergo a self-diagnostic test.
Inserting and Removing Battery Packs
To insert a battery pack, place the end of the battery without the locking tab into the bottom of the charging pocket and snap the
battery into place with a hinging motion. Once the battery is properly seated, the orange status LED for that particular pocket will
illuminate.
battery into place with a hinging motion. Once the battery is properly seated, the orange status LED for that particular pocket will
illuminate.
For best results, battery packs should be at room temperature before recharging them; temperature has a marked effect on
charging. The recommended temperature range is 50° to 95° F (10
charging. The recommended temperature range is 50° to 95° F (10
° to 35° C).
The LEDs indicate the charging status of batteries as described in the chart shown on the next page:
Rear Panel of Dolphin 9500/9550Quad Charger
Power Supply Connector