Honeywell International Inc. 950009 Manuale Utente

Dolphin 9500/9550 terminal loaded with an 802.11b radio contain a configuration utility that enables you to enter and save the 
optimal transmission settings.

You can access the configuration utility two ways:

1. Tap Start > Settings > System tab > HHP WLAN Settings 

.

This icon appears on the System tab only if there is an 802.11b radio installed on the terminal.

2. Tap the Status icon 

 - see 

The configuration utility consists of four tabs: Status, Config, Advanced, and About. Each tab is described in its own section in 
this chapter.

HHP WLAN Settings always opens to the Status tab, which displays the current WLAN settings for 802.11b. 

Shows the RF channel currently used by the card.

Shows the current transmit rate. This can be 1 Mbps, 2 Mbps, 5.5 Mbps, or 11 Mbps.

Gives signal to noise ratio in both percentage and graphical display.

Gives signal strength of the receiver in both percentage and graphical display.

IP Address - IP address of the radio. Check with your network administrator for IP configuration 
information. 

Shows the Network Name and the MAC address of:  

- the access point the card is associated with in AP mode, or 

- the creator of IBSS into which the card is joined in peer-to-peer (Ad-Hoc) mode.