Honeywell International Inc. 950009 Manuale Utente

The charger must be connected to the appropriate power source for any type of operation. 

1. Locate the AC power cord that came with the Dolphin QuadCharger. 

2. Plug the cord into the power supply connector on the back of the unit and then plug the power cord into a wall socket. 

3. Press the power switch to the ON position.

The power LED illuminates green, and the charger performs a self-diagnostic test that lasts approximately five seconds.

To insert a battery pack, place the end of the battery without the locking tab into the bottom of the charging pocket and snap the 
battery into place with a hinging motion. The Status LED for that particular slot illuminates orange when the battery has been 
properly inserted.

To remove a battery pack, push the locking tab down and pull the battery out from the charging slot with a hinging motion.

To maintain top performance from batteries, follow these storage guidelines:

•

Avoid storing batteries outside of the specified temperature range of -4 to 104° F (-20 to 40°C) or in extremely high humidity.

•

For prolonged storage, do not keep batteries stored in a charger that is connected to a power source. 

For best results, battery packs should be at room temperature before recharging them; temperature has a marked effect on 
charging. The recommended temperature range is 50° to 95° F (10

°

 to 35

°

 C). 

Complete these steps:

1. Set up the QuadCharger.

2. Supply the QuadCharger with power and turn the power switch on.

3. Insert batteries into the appropriate slots. The Status LED for each slot turns orange to indicate that the battery has begun a 

charge cycle.

4. When the Status LED turns green, the battery in the slot has completed charging.