Honeywell International Inc. 9500LUPE Manuale Utente

Enter the name of this record. This is the name that appears in the Configured Networks list and, by 
default, is the same as the broadcast SSID. Note that there is nothing special about the name "default". 
You could configure any other record similarly and it would behave the same way.

This is the SSID of the AP. If the AP broadcasts its SSID, then this value may be derived from the Avail-
able Networks list. If the SSID does not broadcast, then you must manually enter the value here.

Select this option to have two or more client workstations communicate with each other without the ben-
efit of an AP. You should also select Do Active Scan and, in the WEP Management page, enable Use 
key for data encryption while entering a common key for both sides. 
WPA is not supported in this mode.

Select this option whenever the AP (or client, for ad hoc mode) is not broadcasting its SSID. 

Select the Client Configuration (user) profile associated with this network. The drop-down list contains 
the profile names created onn the User tab of the Client configuration area.
To open the selected profile, select it in the drop-down list and tap View. The User tab opens displaying 
the profile details. If you tap OK (to save changes) or Cancel, you are returned to the Profile Info tab.

This option is selected by default. If this option is selected, the other WEP settings on this page 
are disabled. To enter a custom WEP, de-select this option. The other fields become active.

Select this option to manually enter a WEP key to encrypt your data to the AP. You enter that key 
in the Key field below.

Select this option if your network does not support 802.1x authentication and you need to con-
nect to the AP without username and password authentication. The key entered below is used to 
authenticate instead.