Honeywell International Inc. 99EXLW Manuale Utente

Pagina di 192
Preliminary Draft 1/19/11 
1 - 3 
 
 
 
 
The equipment is intended for use throughout the European Community; PAN European Frequency 
Range: 2.402–2.480 GHz. Restrictions for use in France are as follows: 
•   Indoor use: Maximum power (EIRP*) of 100 mW for the entire 2.400–2.4835 GHz 
•   Outdoor use: Maximum power (EIRP*) of 100 mW for the 2.400–2.454 GHz band & maximum power 
(EIRP*) of 10 mW for the 2.454–2.483 MGHz band. 
•   5Ghz band: UNII (Unlicensed National Information Infrastructure) or band1 (5.150 to 5.250 GHz) is 
restricted to indoor use only. Any other use will make the operation of the device illegal. 
For further information, please contact: 
Honeywell Scanning & Mobility Europe BV 
Nijverheidsweg 9 
5627 BT Eindhoven 
The Netherlands 
 
 
FCC Requirements 
 
 
Dolphin RF Terminal—802.11a/b/g/n, Bluetooth, and/or GSM 
 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 
(1) this device may not cause harmful interference, and (2) this device must accept any interference 
received, including interference that may cause undesired operation. 
This equipment has been tested and found to comply with the limits for a Class B digital device pursuant 
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses, and can radiate radio 
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to radio or television reception, 
which can be determined by turning the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures: 
•   Reorient or relocate the receiving antenna. 
•   Increase the separation between the equipment and receiver. 
•   Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
•   Consult the dealer or an experienced radio/TV technician for help. 
In accordance with FCC 15.21, changes or modifications not expressly approved by the party 
responsible for compliance could void the user’s authority to operate the equipment. 
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any 
other antenna or transmitter. 
If necessary, the user should consult the dealer or an experienced radio/television technician for 
additional suggestions. The user may find the following booklet helpful: “Something About Interference.” 
This is available at FCC local regional offices. Our company is not responsible for any radio or television 
interference caused by unauthorized modifications of this equipment or the substitution or attachment of 
connecting cables and equipment other than those specified by our company. The correction is the 
responsibility of the user. Use only shielded data cables with this system.