Honeywell International Inc. MX2702 Manuale Utente

2 - 7

Automatic Direct Connect Mode: This selection can be used if you have an
IBM AT style terminal and the system is dropping characters.

Default = Off

Connecting the Base with RS-232 Serial Port

1. Turn off power to the terminal/computer.

2. Connect the appropriate interface cable to the base.

Note: For the base to work properly, you must have the correct cable for your

type of terminal/computer.

3. Plug the serial connector into the serial port on your computer. Tighten the

two screws to secure the connector to the port.

4. Plug the power supply barrel connector to the base, and plug the power

supply into the AC source.

5. Once the base has been fully connected, power up the computer.

Automatic Direct

Connect Mode On

* Automatic Direct Connect

Mode Off