Honeywell International Inc. QC900A Manuale Utente

the illumination will turn off.  If the calibration process is successful, the 
following screen displays.

5. Enter the prompted data (Name and Location) and press OK.  The following 

screen displays.

6. If the unit does not calibrate, contact Hand Held Products Technical Support 

1. Turn on the verifier and confirm that it is operational (i.e., does not need to be 

charged or calibrated).

2. Hold the pen wand as you would a pen or pencil, placing your fingers on 

each side of the foot near the tip.

Hold the mouse wand as you would a computer mouse.

3. Lightly touch the wand against either quiet zone (clear area) on either side of 

the bar code. For the pen wand, you will have the proper scanning angle 
when the tip and the reflectance guide (black plastic clamp) are flat on the 
scanning surface.

4. At about the same speed with which you would quickly underline a sentence 

in this manual, and without interruption, gently move the wand across the 
center of the bar code. You do not need to press hard on the wand while 
scanning the bar code. Gentle pressure on the wand will not scratch the 
contacted surface, but pressing down hard may damage the code and yield 
poor results.

5. Listen for audible tones.