Honeywell International Inc. QC900A Manuale Utente
B - 1
B
Menu Setting Bar Codes
The QC890 bar code verifiers are programmed in the factory for the most
common settings. If you need to change these settings, programming is
accomplished by scanning the bar codes included in this chapter.
common settings. If you need to change these settings, programming is
accomplished by scanning the bar codes included in this chapter.
An asterisk (*) next to an option indicates the default setting.
Resetting the Standard Product Defaults
If you aren’t sure what programming options are in your device, or you’ve
changed some options and want the factory settings restored, scan the
Standard Product Default Settings bar code below.
changed some options and want the factory settings restored, scan the
Standard Product Default Settings bar code below.
Illumination Timer
Scan the appropriate bar code to set the duration (in seconds) of the illumination.
Default = 5 seconds.
Default = 5 seconds.
Power Down Timer
Note: This option applies to battery operation only.
When there is no activity within a specified time period, the QC890 Verifier enters
low power mode. Scan the appropriate Power Time-Out bar code to change the
time-out duration (in seconds).
low power mode. Scan the appropriate Power Time-Out bar code to change the
time-out duration (in seconds).
Note: Scanning zero (0) is the equivalent of setting no time-out.
Standard Product Default Settings
3 seconds
*5 seconds
15 seconds