Honeywell International Inc. CTU-K07 Manuale Utente

To connect the cables, follow these steps: 

1.  Before connecting the cables, insert the power supply jumpers. 

2.  Line up the cables with the grooves at the back of the terminal (see  Figure 

6) and screw in the small plate which serves as a cable clamp (use a 

∅

 

5mm Philips screwdriver). 

 

 

3.  Attach the wire pin connectors to the terminals located on the lower part of 

the terminal unit. (use a 

∅

 3mm flat head screwdriver). 

4.  Insert the cable in the corresponding connector (see  Figure 7) to complete 

the connection to the LAN Ethernet 10BaseT (twisted pair). 

Figure 9 illustrates the connections and settings of jumpers JP2 and JP3 on 
the display control board. Make sure that both jumpers are in the position 
shown in Figure 9 (MAG-TEK interface).