Honeywell International Inc. CTU-K07 Manuale Utente
Page 10
Connecting the Cables
Connecting the Cables
To connect the cables, follow these steps:
1. Before connecting the cables, insert the power supply jumpers.
WARNING
Do not press the anti-opening tamper during installation and/or
maintenance of the unit.
maintenance of the unit.
2. Line up the cables with the grooves at the back of the terminal (see Figure
6) and screw in the small plate which serves as a cable clamp (use a
∅
5mm Philips screwdriver).
Fasten cable clamp
board (8 screws)
board (8 screws)
Lock cables
Figure 6: Connecting the cables
3. Attach the wire pin connectors to the terminals located on the lower part of
the terminal unit. (use a
∅
3mm flat head screwdriver).
4. Insert the cable in the corresponding connector (see Figure 7) to complete
the connection to the LAN Ethernet 10BaseT (twisted pair).
Figure 9 illustrates the connections and settings of jumpers JP2 and JP3 on
the display control board. Make sure that both jumpers are in the position
shown in Figure 9 (MAG-TEK interface).
the display control board. Make sure that both jumpers are in the position
shown in Figure 9 (MAG-TEK interface).