Honeywell International Inc. REM5000R01 Manuale Utente
3
Español: vea la página 7 • Français : voir la page 13
Link remote control to wireless network
1 Make sure the Connected light on the
EIM or wireless adapter is flashing
(see page 2).
(see page 2).
2 Press
CONNECT
at the remote. There will
be a short delay as the remote seeks
a signal from the wireless network.
a signal from the wireless network.
3 When the screen displays
“Connected,” press
DONE
.
4 Press
NO
at the next screen to save and
exit. (Or press
YES
and repeat steps 1-4
to link another EIM/zone panel.)
Link outdoor sensor to wireless network
1 Make sure the Connected light on the
EIM or wireless adapter is flashing
(see page 2).
(see page 2).
2 Press the
CONNECT
button on the back
of the sensor.
3 Check thermostat to verify that the
outdoor sensor is working. After
about 15 seconds, the thermostat
should display outdoor temperature
and humidity.
about 15 seconds, the thermostat
should display outdoor temperature
and humidity.
(If there is more than one EIM/zone
panel, repeat steps 1-3 for each.)
panel, repeat steps 1-3 for each.)
Press and release
If E1 appears, see error codes on page 5.
WIRELESS SETUP
CONNECT
YES
NO
CONNECT MORE?
The linking procedure may time out if there is
no keypress within 30 minutes. To begin again,
press and hold the blank space (or arrow if
present) in the lower right corner of the screen
until the display changes (about 3 seconds)
no keypress within 30 minutes. To begin again,
press and hold the blank space (or arrow if
present) in the lower right corner of the screen
until the display changes (about 3 seconds)
Press to link another
EIM or zone panel
EIM or zone panel
Press to save
and exit
and exit