Honeywell International Inc. GPIO332 Manuale Utente
© Honeywell
Page 2 - Printed in USA
LT-GP-II-01 Rev. A
Wiring
Once the GP-IO-332 is mounted, connect the power.
Fig. 2 Wiring diagram.
Connecting power
Connect the GP-IO-332 to 24VAC power from a UL
Listed Class-2 24VAC transformer (not included). You
can use the same transformer for the GP-HUB-100 and
other associated controller(s) as long as the total load
does not exceed 100VA and all devices are half-wave.
The GP-IO-332 is a half-wave device.
Listed Class-2 24VAC transformer (not included). You
can use the same transformer for the GP-HUB-100 and
other associated controller(s) as long as the total load
does not exceed 100VA and all devices are half-wave.
The GP-IO-332 is a half-wave device.
CAUTION! Half-wave devices and full-wave devices must not
use the same AC transformer. You must maintain wiring
polarity. Failure to do so can result in equipment damage.
use the same AC transformer. You must maintain wiring
polarity. Failure to do so can result in equipment damage.
ATTENTION! Les dispositifs demi-onde et les dispositifs à
onde pleine ne doivent pas utiliser le même transformateur AC.
Le défaut de maintient de la polarité du câblage peut
endommager l'équipement.
onde pleine ne doivent pas utiliser le même transformateur AC.
Le défaut de maintient de la polarité du câblage peut
endommager l'équipement.
USB Power
The GP-IO-332 can also be powered from a USB cable
that provides 5VDC power. Some USB ports can supply
sufficient power and some can not. Review the user
documentation for the power source to determine
whether the USB port supplies sufficient power.
that provides 5VDC power. Some USB ports can supply
sufficient power and some can not. Review the user
documentation for the power source to determine
whether the USB port supplies sufficient power.
DIP Switches
The GP-IO-332 has two banks of DIP switches. The first,
6-position switch, sets the network address for the
wireless network (must match GP-HUB-100). The
second, 8-position switch, is used to set the Remote
Device address (0-99) that the device will use when
connecting to the Hub.
6-position switch, sets the network address for the
wireless network (must match GP-HUB-100). The
second, 8-position switch, is used to set the Remote
Device address (0-99) that the device will use when
connecting to the Hub.
The RSSI LEDs also flash to indicate error conditions.
Fig. 3 Locations of GP-IO-332 components.
XX
XX
XXX
XXXXXXX
GND
COM
24V
AC
MSTP-
POWER
MSTP+
XFMR
24VAC
O/P
FUSED AC
SOURCE
PANEL GROUND
Table 1 RSSI Error Conditions
Flash Pattern
Status
One red
No communication or the device has not
joined the wireless network
joined the wireless network
One yellow and two
green
green
Wireless network MAC address does not
match device type
match device type
Two green
Multiple devices have identical wireless
network MAC addresses
network MAC addresses
One red and one green Lost communication with GP-HUB-100.
Working to re-establish connection.
One flashing red and
two solid green
two solid green
Device initialization in progress
BO LED
AC POWER
TERMINALS
TERMINALS
USB
TERMINALS
TERMINALS
AI TERMINALS
BO TERMINALS AO TERMINALS