Fujitsu Technology Solutions GmbH SCENIC6651 Manuale Utente
System expansions
34
A26361-K520-Z200-1-7619
1
a
3
2
Ê
Push the board up to its slot (1).
Ensure that the end of a long board without angle bracket fits into the corresponding guide of
the system unit. Ensure also that the point of the angle bracket slots into guide (a).
Ensure that the end of a long board without angle bracket fits into the corresponding guide of
the system unit. Ensure also that the point of the angle bracket slots into guide (a).
Ê
Press the board into the slot so that it engages.
Ê
Replace the clip (2) which fixes the board. Make sure that the clip engages when released (3).
Ê
If necessary, plug the lines on the board.
Ê
Close the system unit (see "
Assembling the system unit
").
Removing a board
Ê
Open the system unit (see "
Opening the system unit
").
Ê
Remove the lines connected to the board.
3
1
2
Ê
Press on the clip in the direction of the arrow (1) and remove it (2).
Ê
Remove the board from the system unit (3).
Ê
Place the board into an appropriate packaging.
!
For cooling, protection against fire and in order to comply with EMC (electromagnetic
compatibility) regulations, you must refit the rear slot cover plate.
compatibility) regulations, you must refit the rear slot cover plate.