Murata Electronics North America 910M Manuale Utente
WIT910
Receiving terminal drops characters periodically.
Set the number of retries to a high number and send a few characters. Check that the
transmitted data can get through under these conditions. Sometimes this symptom is
caused by an application that is explicitly dependent on the timing of the received data
stream. The nature of the packetized RF channel imposes a degree of unpredictability in
the end-to-end transmission delay.
Cannot communicate with the OEM module.
Make sure DTR and RTS are asserted. DSR should be on to indicate the radio is ready.
OEM Module is in an unknown state.
Use the
m0
command to restore the factory defaults. Note that the serial baud rate must be
known for the module to receive this command.
© 2000- 2004 Cirronet™ Inc
36
M-0910-0000 Rev -