The Whistler Group SC04 Manuale Utente
13
DC Power Cable
Connect the supplied DC power cable to a vehicle
power source:
power source:
1. Disconnect your battery's negative (-) terminal.
NOTE: Disconnecting your battery may reset some
devices in your vehicle, such as automotive audio
systems, navigation systems, or alarm systems.
devices in your vehicle, such as automotive audio
systems, navigation systems, or alarm systems.
2. Route the suppled DC power cord between a
power source and the mounting location for
your scanner.
your scanner.
3. Ground the power cord's black wire to your
vehicle’s chassis.
NOTE: The grounding screw must make complete
contact with the metal frame of your vehicle.
contact with the metal frame of your vehicle.
4. Connect the power cord's red wire to a voltage
source that turns on and off with the ignition
switch, such as a spare accessory terminal in
your vehicle’s fuse box.
switch, such as a spare accessory terminal in
your vehicle’s fuse box.
5. Insert the power plug into the DC power jack on
the rear of the radio.
6. Reconnect the cable to the negative (-) terminal
of your vehicle’s battery.
NOTE: If your vehicle’s engine is running, you might
hear electrical noise from the engine while scanning.
This is normal.
hear electrical noise from the engine while scanning.
This is normal.
WARNING: The DC power cord is equipped with
an inline fuse. This fuse protects your scanner and
your vehicle from damage in case of equipment
malfunction or a short circuit. Do not remove the
inline fuse holder from the DC power cord. If the
fuse blows, replace it with a 2A fuse and apply power
again. If the fuse blows again, check all wiring for
short circuits, and check the radio for a malfunction.
an inline fuse. This fuse protects your scanner and
your vehicle from damage in case of equipment
malfunction or a short circuit. Do not remove the
inline fuse holder from the DC power cord. If the
fuse blows, replace it with a 2A fuse and apply power
again. If the fuse blows again, check all wiring for
short circuits, and check the radio for a malfunction.