Powerwave Technologies Inc. MCPS2135 Manuale Utente
MCPS2135 InstallationPlanning and Preparation
Introduction
18
MCPS2135 Operations Manual
2001 Spectrian Corporation. All rights reserved.
with local building codes and industry practice. Refer to Table 2 for the
recommended power supply circuit and wire sizing for each option.
recommended power supply circuit and wire sizing for each option.
+
WARNING: Do not perform DC lead installation with energized leads. Ensure
that the DC power supply is OFF for all installation activities!
that the DC power supply is OFF for all installation activities!
1. Locate the positive and n egative terminals on the customer-provided DC
power source, and verify polarity with a DVM.
2. Locate the power supply lugs at the top of the rear of the shelf
subassembly. The four #10 lugs are for the per-RF-Module connection
option, the single pair of ¼” lugs are for the bussed power option.
Determine which set of lugs will be used for this installation.
option, the single pair of ¼” lugs are for the bussed power option.
Determine which set of lugs will be used for this installation.
3. Measure the distance and routing between the power source and the
MCPS2135 DC lugs.
4. For each power connection being made, cut equal lengths of wire for
power and return. Strip and connect each wire to the appropriate power
connection, using the crimping tool and the supplied ground lug.
connection, using the crimping tool and the supplied ground lug.
∗
Caution: Verify the polarity of each supply wire prior to connecting them to the
shelf subassembly. A reversed-polarity connection will severely damage the
MCPS2135 and will void the product warranty.
shelf subassembly. A reversed-polarity connection will severely damage the
MCPS2135 and will void the product warranty.
5. Crimp the appropriate terminal lugs onto each power supply wire.
6. Attach one positive supply wire and one return wire to each of the four
sets the power supply lugs at the top of the rear of the shelf subassembly.
Tighten the attachment nuts firmly.
Tighten the attachment nuts firmly.
7. Inspect the finished connection. If no problems exist, the DC input power
cable installation is complete.
3.4.3 Connect RF Output and Input Cables
The MCPS2135 has one
female type-N amplified RF output for connection to a
customer-supplied coaxial cable terminated with a male connector, and one female
SMA RF input for connection to an customer-supplied input cable terminated with
a male SMA connector.
SMA RF input for connection to an customer-supplied input cable terminated with
a male SMA connector.
+
WARNING: Do not perform RF cable installation with DC power applied to the
MCPS2135. Ensure that the input DC power supply is OFF before handling RF
cables.
MCPS2135. Ensure that the input DC power supply is OFF before handling RF
cables.
∗
Caution: The Output cable must be connected before connecting the Input
cable.
cable.
.
Note: The integrity of RF cabling is critical to the electrical performance of the
MCPS2135. Ensure connectors are properly assembled, are free of debris, and
are clean.
MCPS2135. Ensure connectors are properly assembled, are free of debris, and
are clean.
1. Locate the male N-type RF output connector on the end of the coaxial
cable attached to the output load. Inspect the connector and clean if
necessary; fix any problems with the cable or connector before
proceeding.
necessary; fix any problems with the cable or connector before
proceeding.