Senstar Corporation LM100 Manuale Utente

Sequencing can be done by 1 person who starts the recording and then does the location tests, or 
by 2 people with 1 monitoring the UCM and the other doing the location tests. To determine the 
physical position of each luminaire, and put them into an ordered list, 1 person goes around the 
perimeter fence causing a disturbance at each luminaire while the results are recorded on the 
UCM. The luminaire AP is the recommended starting point for the sequencing procedure. 
However, for your site-specific sensor layout you may prefer to begin at a particular corner or 
some other identifiable feature.

Step 1: The Unordered Heads table is populated automatically by selecting the Record button. 
The Unordered Heads table includes a numbered list of all luminaires that are communicating on 
the wireless mesh network. Each luminaire is identified by a 5-digit mesh network Id. The 
Unordered Heads list is based on the luminaires’ RF communication pattern rather than the 
installation locations. This process can take several minutes to complete.

Step 2: The Ordered Heads table is completed by conducting location tests to identify specific 
luminaires. The luminaires are moved automatically into the Ordered Heads table in the same 
order as the location tests are conducted. This enables the luminaires to be organized so that 
numerically sequential luminaires can be assigned to segments, regardless of their 
communication pattern. The segments are then assigned to zones for alarm reporting and routine 
scheduled lighting.

Step 3: The Head Sequence table is completed manually by moving the heads from the Ordered 
Heads table. The Heads Sequence table also includes segment and zone number assignments, 
once the segments and zones are defined in the segment setting window on the Config tab.

Senstar LM100 heads are organized into segments and zones in the 
same manner as a FlexZone sensor cable. 

The Define Head Sequence window includes 3 indicate buttons to 
assist in identifying specific luminaires. Select a luminaire from a list, 
select the indicate button below the list, and the specified head will flash 
5 times.

Figure 48: Define head sequence window (Unordered Heads)

select the Sequence button

select the Record button to

create a list of unordered

(becomes Stop button

to open the Define

while recording)

Head Sequence window

heads