ZyXEL Communications Corporation WAC6553D-E Manuale Utente
Chapter 1 Introduction
NWA5000 / WAC6500 Series User’s Guide
18
1.5 NWA5301-NJ Hardware
1.5.1 110 Punch-Down Block
This section shows you how to use a punch-down tool to seat an 8-wire Ethernet cable to the 110
punch-down block. You can connect a PoE switch to the 110 punch-down block to provide power
and Internet access to the NWA through this connection. An 8-pin Ethernet cable has four pairs of
color coded wires.
punch-down block. You can connect a PoE switch to the 110 punch-down block to provide power
and Internet access to the NWA through this connection. An 8-pin Ethernet cable has four pairs of
color coded wires.
1
Cut out one and a half inches of the jacket from the Ethernet cable to expose the wires.
2
Untwist the wire pairs no more than one inch.
3
Match each wire to the correct slot according to the color codes for wiring shown below.
4
Use a punch-down tool to seat the wires down properly into the slot.
Table 4
Color Codes for 110 Punch Down Block Wiring
PIN#
WIRE COLOR
1
White/Orange
2
Orange
3
White/Green
4
Blue
5
White/Blue
6
Green
7
White/Brown
8
Brown
PIN#
PHONE
PORT
PORT
UPLINK
PORT
PORT
NWA Rear Panel