ZyXEL Communications Corporation WAP6806 Manuale Utente

 Chapter 15 Troubleshooting

WAP6806 User’s Guide

If the problem continues, contact the network administrator or vendor, or try one of the advanced 
suggestions.

• Check the settings for QoS. If it is disabled, you might consider activating it.

If you reset the WAP6806, you lose all of the changes you have made. The WAP6806 re-loads its 
default settings, and the password resets to 1234. You have to make all of your changes again.

You will lose all of your changes when you reset the WAP6806 to its factory defaults.

To reset the WAP6806,

Make sure the power LED is on.

Press the RESET button for longer than 10 seconds, the Power LED begins to blink, to set the 
WAP6806 back to its factory-default configuration.

OR

Click Maintenance > Backup/Restore > Restore and then click Reset.

If the WAP6806 restarts automatically, wait for the WAP6806 to finish restarting, and log in to the 
Web Configurator. The password is 1234.

If the WAP6806 does not restart automatically, disconnect and reconnect the WAP6806’s power. 
Then, follow the directions above again.

I cannot access the WAP6806 or ping any computer from the WLAN.

Make sure the wireless LAN is enabled on the WAP6806.

Make sure the wireless adapter on the wireless station is working properly.

Make sure the wireless adapter installed on your computer is IEEE 802.11 compatible and supports 
the same wireless standard as the WAP6806.

Make sure your computer (with a wireless adapter installed) is within the transmission range of the 
WAP6806.