COOPER INDUSTRIES INC FH1847N Manuale Utente
T245 Control System Manual
18
Legend (Right Digit)
Information Shown (Left Three Digits)
adjusted and will only appear in Factory Setup mode. Please
see 9. Factory Parameters for more information.
see 9. Factory Parameters for more information.
1
Boom Extension Switches
†
:
100 = Upper Boom Extended,
10 = Intermediate Boom Retracted,
1 = Upper Boom Retracted
10 = Intermediate Boom Retracted,
1 = Upper Boom Retracted
2
Boom Stow Switches:
100 = Auger Overstow,
10 = Boom Stowed
100 = Auger Overstow,
10 = Boom Stowed
To change between these displays, press the DISPLAY button. The display will
always start at LOAD % after releasing the transmitter’s EMERGENCY STOP. Holding
the DISPLAY button for more than two seconds will also return the display to LOAD %.
the DISPLAY button for more than two seconds will also return the display to LOAD %.
The display will only work when the transmitter is switched on and its
EMERGENCY STOP is released (the
STOP
light must not be on or flashing); otherwise,
the display will show three dashes (“- - -”) in place of numbers. If the T247 Cable
Remote is plugged in and switched on, the display on the T245/T45 Transmitter will stop
working and the information will be displayed on the T247’s display instead.
Remote is plugged in and switched on, the display on the T245/T45 Transmitter will stop
working and the information will be displayed on the T247’s display instead.
The display in the newer T245 will operate whenever the T245 is in control of the
VXD, with a range of about 1200 feet (line-of-sight). The display in the older T45 will
operate within a 100-foot (approximate) radius of the Receiver/Controller’s antenna;
however, the remote control of the machine will operate over a range of about 1200 feet.
Should the display in the older T45 stop working because you are too far from the
machine, you can still safely operate the controls but you will not be able to read the
status information.
operate within a 100-foot (approximate) radius of the Receiver/Controller’s antenna;
however, the remote control of the machine will operate over a range of about 1200 feet.
Should the display in the older T45 stop working because you are too far from the
machine, you can still safely operate the controls but you will not be able to read the
status information.
7.3. T247/T47 Cable Remote
If you have purchased the optional T247 or T47 Cable Remote, you may operate
the Control System with all of the electronic safety features afforded with the Radio
Transmitter, but via a hardwire (cable). To activate the T247/T47 Cable Remote, release
the red Emergency Stop button and switch on the POWER switch—the control of the
machine is now taken away from the Radio Transmitter and given to the Cable Remote.
All control functions operate as in the Radio Transmitter.
Transmitter, but via a hardwire (cable). To activate the T247/T47 Cable Remote, release
the red Emergency Stop button and switch on the POWER switch—the control of the
machine is now taken away from the Radio Transmitter and given to the Cable Remote.
All control functions operate as in the Radio Transmitter.
Note that for safety, the Cable Remote’s Emergency Stop button must be released
even when operating from the Radio Transmitter (Cable Remote POWER switch turned
off); this allows someone to stop the machine at the Cable Remote.
off); this allows someone to stop the machine at the Cable Remote.
†
If more than one switch is on, the values are added. Hence, the display “1011” indicates that the Upper
Boom Extended switch is on, the Intermediate Boom Retracted switch is off, and the Upper Boom
Retracted switch is on.
Retracted switch is on.