COOPER INDUSTRIES INC FH1848D Manuale Utente
13
set switches 1 through 8 to OFF, ON, ON, OFF, OFF, ON, OFF, ON, and switches 9
through 16 to ON, ON, ON, ON, OFF, OFF, OFF, ON.
through 16 to ON, ON, ON, ON, OFF, OFF, OFF, ON.
6.2. No-Link Data Mode
The last bank of switches (“MODE”) on the DEX-900 is used to select various
features on DEX-900. For the Versalift Controller/Receiver, only position 5 should
be ON. This sets the DEX-900 to clear all its output data whenever there is no link or
signal from the Radio Transmitter of the right ID.
be ON. This sets the DEX-900 to clear all its output data whenever there is no link or
signal from the Radio Transmitter of the right ID.
6.3. Changing Switch Settings
To change the switch settings, use a ballpoint pen or small screwdriver to move
the switch levers. When you have set the levers to the right positions, turn the system
power off (usually by shutting off the vehicle’s PTO switch) and back on again. The
DEX-900 will take about 5 seconds to process your changes and then turn on its red ON
lamp. You must switch the power off and on whenever you change the DEX-900
switches, for the changes to take effect.
power off (usually by shutting off the vehicle’s PTO switch) and back on again. The
DEX-900 will take about 5 seconds to process your changes and then turn on its red ON
lamp. You must switch the power off and on whenever you change the DEX-900
switches, for the changes to take effect.