COOPER INDUSTRIES INC FH1848D Manuale Utente
4
2. Physical Mounting
The Controller/Receiver should be mounted with the connectors down, and in a
location so that the enclosure door may be opened conveniently for access to the inside.
Shock mounts must be used to mount the enclosure! Under no circumstances
should the enclosure be directly bolted to the machine. Figure 1 below illustrates how the
shock mounts should be installed:
shock mounts should be installed:
Figure 1 Enclosure Mounting
The Controller/Receiver enclosure is sealed and has a NEMA-4 rating. When
installing, ensure that nothing is done to compromise the watertightness of the enclosure.
When performing maintenance it may be necessary to gain access to the inside of the
enclosure; take care to re-close the door securely when you are done.
When performing maintenance it may be necessary to gain access to the inside of the
enclosure; take care to re-close the door securely when you are done.
The receiver antenna should be mounted pointing up and as high as possible,
preferably with a large metal surface below it but no metal above or to the side. The
antenna must be mounted on the outside of the machine; do not mount it inside an
operator’s cab or in a toolbox. Assemble the antenna as shown in Figure 2 below, and
thread (finger-tight only) the connector onto the matching receptacle on the
Controller/Receiver.
antenna must be mounted on the outside of the machine; do not mount it inside an
operator’s cab or in a toolbox. Assemble the antenna as shown in Figure 2 below, and
thread (finger-tight only) the connector onto the matching receptacle on the
Controller/Receiver.
Figure 2 Antenna Assembly