COOPER INDUSTRIES INC LPD24RC Manuale Utente
7
DMAN-xxxx-xx
www.omnexcontrols.com
call toll free: 1-800-663-8806
Light Legend
Solid
Slow
Flash
Flash
Fast
Flash
Flash
Red
Light
Light
Green
Light
Light
Alternating Red
& Green Light
& Green Light
Yellow
Light
Light
Follow these steps to download the transmitter’s unique ID Code into the receiver. This will allow the receiver to establish
a Radio link with a specific transmitter. Refer to Trouble Shooting Chart #4 for Tips and Considerations
a Radio link with a specific transmitter. Refer to Trouble Shooting Chart #4 for Tips and Considerations
NOTE: It is necessary to download the ID code when replacing either the transmitter or the receiver.
NOTE: If the transmitter is connected to the receiver with a Tether Cable, completing only steps 4 and 6 is necessary (it is not
necessary to open the R2160 case and press the Setup button).
NOTE: If the transmitter is connected to the receiver with a Tether Cable, completing only steps 4 and 6 is necessary (it is not
necessary to open the R2160 case and press the Setup button).
Follow these steps to ensure that there is a Radio Link between the transmitter and receiver
Refer to the Light Legend below for diagram details
1. Press [E-Stop]
ESTOP FAULT LINK STATUS
2. Power the R2160
ESTOP FAULT LINK STATUS
3. Power the T2300
If the (Active) light on the transmit-
ter is flashing and the (Link) light
on the receiver is flashing GREEN,
a link between the two exists.
ter is flashing and the (Link) light
on the receiver is flashing GREEN,
a link between the two exists.
The (E Stop) light and the (Link)
light will come on RED (provided the
transmitter is off), and the (Status)
light will come on GREEN.
light will come on RED (provided the
transmitter is off), and the (Status)
light will come on GREEN.
NOTE:
The transmitter will shut itself off (and the receiver will then shut off all outputs) after 4 hours of inactivity as a battery saving feature. To restart
the timer before the transmitter shuts off automatically, momentarily operate any toggle switch or paddle.
The ORIGA System is now ready for use.
If the receiver's (Link) light does not become GREEN follow the steps under Download ID Code.
The cap is held on by two plastic tabs at
opposing sides, which can be unlatched as
shown using a screwdriver. Once the cap
is free, the R2160 can slide open.
opposing sides, which can be unlatched as
shown using a screwdriver. Once the cap
is free, the R2160 can slide open.
Use a small slotted screwdriver to press the
Side Tabs inward.
Side Tabs inward.
ESTOP FAULT LINK STATUS
1. Opening the R2160
A. Press [E-Stop]
B. Twist CW & release [E-Stop]
2. Prepare T2300
A.
B.
Test the Transmitter / Receiver Link
Download ID Code
(Use in case of Link Test failure)