L3 Technologies AISA1 Manuale Utente
Marine Systems
Aviation Recorders
Initial Issue
Dec. 01/06
165M0014-10
Page 3–3
Page 3–3
ProTec AIS Installation
3.1.
Installation
The L-3 ProTec Transponder has been designed for easy installation into any exist-
ing bridge layout. Figure 3–1 gives a general representation of the system layout.
Installation can be broken down into 5 distinct operations as follows:
ing bridge layout. Figure 3–1 gives a general representation of the system layout.
Installation can be broken down into 5 distinct operations as follows:
F
Transponder
F
VHF Antenna
F
GPS Antenna
F
Data Interface
F
Powerup and Configuration
Each operation will be discussed in detail below. In regards to 3rd part components
such as VHF and GPS antennas and Gyro interfaces, it is suggested that the
installation procedures suggested by the manufacturer be followed in lieu of these
procedures.
such as VHF and GPS antennas and Gyro interfaces, it is suggested that the
installation procedures suggested by the manufacturer be followed in lieu of these
procedures.
Junction
Box
IEC 61162 HDG, ROT
TRANSPONDER UNIT
IEC 61162 HDG, SOG, COG, ROT, POSN
POSN, SOG, COG
SHIP
SENSORS
(Optional)
RADAR
ECDIS
PILOT/PC
AIS DATA
AIS DATA
AIS DATA
AIS DATA
VHF Antenna
150M-W2VN
GPS
24VDC - 10 Amp
Power
PILOT/PC
24 VDC
(Optional)
communications
PILOT
AUTOMATIC IDENTIFICATION SYSTEM
STATUS
ON / OFF / DIM
Figure 3–1. AIS Transponder Interconnection Diagram